The ONVIF (Open Network Video Interface Forum) protocol facilitates interoperability across different brands' devices, ensuring compatibility throughout various systems. This blog will walk you through the process of integrating Litokam cameras into your Blue Iris setup, thereby enhancing the capabilities of your home or office security system.

Contents

• How to Check if Your Camera is ONVIF-Compatible
• How to Connect the Camera to Blue Iris
• How to Control the Camera Using Blue Iris

How to Check if Your Camera is ONVIF-Compatible

There are two ways to verify if your Litokam camera supports ONVIF protocols:

Method 1: Consult the ONVIF Support List

Check the table below that details all Litokam cameras compatible with the ONVIF protocol.

Method 2: Check via the Litokam App

You can easily check for ONVIF support using the Litokam app by following these steps:
1. Open the Litokam app;
2. Navigate to the camera settings page.
3. Look for the “ONVIF” function listed among the settings.

If you do not find your model listed or require additional assistance, please contact our customer service team for support.

How to Connect Your Camera to Blue Iris

Before you begin, make sure your camera is connected to the network, and that Blue Iris software is installed and configured on your computer. 

Note: Ensure both your camera and computer are connected to the same Wi-Fi network.

Step 1 Enable the ONVIF Function in the App

1. Open the camera's live streaming interface in the app.
2. Tap the "..." icon to access the settings page.
3. Enable the ONVIF function.

Note: When enabling the ONVIF function for the first time, you will need to set a new password.

Step 2 Launch Blue Iris, click the "+" icon or right-click to add a device. 

Step 3. Enter the camera's IP address and password.

Step 4. Change the RTSP port to 5543 and the ONVIF port to 8000, then click OK. Now you can view your camera live on Blue Iris.

How to Control the Camera Using Blue Iris?

After successfully adding your Litokam camera to Blue Iris, you can control it by following steps:

1. Right-click on the Blue Iris preview interface.
2. Select Camera Settings > PTZ/Control.
3. Enable Pan, Tilt, Zoom, and other controls button.
4. Save your settings.

If you encounter any issues during setup, please don't hesitate to contact our support team for assistance.